diff options
-rw-r--r-- | lib/libc/gen/sysctl.3 | 46 |
1 files changed, 23 insertions, 23 deletions
diff --git a/lib/libc/gen/sysctl.3 b/lib/libc/gen/sysctl.3 index 25963e3315c..4b6b724a436 100644 --- a/lib/libc/gen/sysctl.3 +++ b/lib/libc/gen/sysctl.3 @@ -1,4 +1,4 @@ -.\" $OpenBSD: sysctl.3,v 1.35 2000/01/07 21:36:39 angelos Exp $ +.\" $OpenBSD: sysctl.3,v 1.36 2000/01/09 22:29:39 angelos Exp $ .\" .\" Copyright (c) 1993 .\" The Regents of the University of California. All rights reserved. @@ -477,31 +477,9 @@ privileges may change the value. .It Dv PF_ROUTE No " routing messages no" .It Dv PF_INET No " IPv4 values yes" .It Dv PF_INET6 No " IPv6 values yes" -.It Dv PF_ENCAP No " IPsec values yes" .El .Pp .Bl -tag -width "123456" -.It Dv PF_ENCAP -Get or set various global information about the -.Tn IP -security protocols. -The third level name is the protocol. -The fourth level name is the variable name. -The currently defined protocols and names are: -.Bl -column "Protocol name" "Variable name" "integer" -offset indent -.It Sy Protocol name Variable name Type Changeable -.It encap encdebug integer yes -.El -.Pp -The variables are as follows: -.Bl -tag -width "123456" -.It Li encap.encdebug -Returns 1 when error message reporting is enabled for the host. -If the kernel has been compiled with the -.Dv ENCDEBUG -option, -then debugging information will also be reported when this variable is set. -.El .It Dv PF_ROUTE Return the entire routing table or a subset of it. The data is returned as a sequence of routing messages (see @@ -530,6 +508,7 @@ The currently defined protocols and names are: .It ip forwarding integer yes .It ip redirect integer yes .It ip ttl integer yes +.It ip encdebug integer yes .It ip4 allow integer yes .It gre allow integer yes .It mobileip allow integer yes @@ -569,6 +548,27 @@ packet sourced by the system. This value applies to normal transport protocols, not to .Tn ICMP . +.It Li ip.encdebug +Returns 1 when error message reporting is enabled for the host. +If the kernel has been compiled with the +.Dv ENCDEBUG +option, +then debugging information will also be reported when this variable is set. +.It Li ip.ipsec-acl +If set to 1, incoming IPsec packets that are successfully +decrypted/authenticated are further validated against a list of acceptable +packet classes per Security Association. +When using automated key management, such as +.Xr isakmpd 8 +or +.Xr photurisd 8 , +the acceptable packet classes should be set up automatically. +When using manual keying, the appropriate entries have to be configured on a +per-SA basis via +.Xr ipsecadm 8 . +If this value is set to 1 and no access control is configured, IPsec packets +will be dropped. +If set to 0, no testing of ingress packets will occur. .It Li ip4.allow If set to 0, incoming IPv4-in-IPv4 packets will not be processed. If set to any other value, processing will occur. |