1 files changed, 63 insertions, 0 deletions
diff --git a/sys/arch/mvme88k/conf/MYBOX b/sys/arch/mvme88k/conf/MYBOX
new file mode 100644
index 00000000000..b6662c4c145
--- /dev/null
+++ b/sys/arch/mvme88k/conf/MYBOX
@@ -0,0 +1,63 @@
+#	$Id: MYBOX,v 1.1 1995/10/18 10:54:18 deraadt Exp $
+
+include "std.m88k"
+
+maxusers	8
+options		TIMEZONE=300, DST=1
+options		BYTE_MSF
+options		SWAPPAGER, VNODEPAGER, DEVPAGER
+#options		INET
+options		FFS, MFS, FDESC
+#options		"COMPAT_42", "COMPAT_43"
+options		GENERIC, KTRACE, DIAGNOSTIC, "NKMEMCLUSTERS=256"
+#options		PANICWAIT, DEBUG, DDB
+options		PANICWAIT, DEBUG, DDB
+
+#options	"CD9660", PORTAL, MSDOSFS, PROCFS, NULLFS, FIFO, KERNFS
+#options	NFSSERVER, NFSCLIENT
+#options	SYSVSHM, SYSVMSG, SYSVSEM	
+#options	SYSCALL_DEBUG, SCSIDEBUG, KGDB
+
+# scsi stuff, all possible
+#m187le0		at mainbus0		# Ethernet
+#m187tty0	at mainbus0		# tty
+#ser0		at mainbus0		# tty
+#ser0		at pcc0			# tty
+
+bugtty0		at mainbus0		# bug tty
+
+# scsi stuff, all possible
+#m187scsi0	at mainbus0
+#bugscsi0	at mainbus0
+#bugscsi0	at pcc0
+
+#scsibus0	at m187scsi0
+#scsibus0	at bugscsi0
+#scsibus0	at scsi0
+#
+# compat.
+#
+#sd0	at scsibus? target 0 lun 0
+#sd1	at scsibus? target 1 lun 0
+#sd2	at scsibus? target 2 lun 0
+#sd3	at scsibus? target 3 lun 0
+#sd4	at scsibus? target 4 lun 0
+#sd5	at scsibus? target 5 lun 0
+#sd6	at scsibus? target 6 lun 0
+
+#
+# This is nicer however many amiga setups expect sd units to refer to
+# scsi target numbers.  If this is not the case, you can remove the 
+# specific sdx lines above and each hard drive from low target to high
+# will configure to the next available sd unit number
+
+#sd*	at scsibus? target ? lun ?	# scsi disks
+#st*	at scsibus? target ? lun ?	# scsi tapes
+#cd*	at scsibus? target ? lun ?	# scsi cd's
+
+#pseudo-device	sl			# slip
+#pseudo-device	ppp			# ppp
+#pseudo-device	pty 16			# pseudo terminals
+#pseudo-device	loop			# network loopback
+#
+config	netbsd swap on generic