| Age | Commit message (Expand) | Author |
|---|
| 2014-09-14 | remove uneeded proc.h includes | Jonathan Gray |
| 2014-09-06 | reduce the amount of pci includes | Jonathan Gray |
| 2014-08-03 | When stsp changed bwi_encap() for 30 bit addresses in rev 1.106 code | Jonathan Gray |
| 2014-07-22 | Fewer <netinet/in_systm.h> | Martin Pieuchot |
| 2014-07-20 | Always allocate bwi(4) ring descriptors below the 1GB boundary to give 30bit | Stefan Sperling |
| 2014-07-20 | In bwi(4), don't declare an interrupt as unhandled in case the PHY TX error | Stefan Sperling |
| 2014-07-20 | Make bwi_dma_mbuf_create() use the correct loop counter in error case. | Stefan Sperling |
| 2014-07-20 | Load bwi(4) firmware once, not every time the interface is brought up. | Stefan Sperling |
| 2014-07-12 | add a size argument to free. will be used soon, but for now default to 0. | Ted Unangst |
| 2014-03-19 | Stop abusing the rcvif pointer to pass wireless nodes down to the | Martin Pieuchot |
| 2013-12-06 | Add a DVACT_WAKEUP op to the *_activate() API. This is called after the | Theo de Raadt |
| 2013-11-14 | replace workqs with tasks for handling resume | David Gwynne |
| 2013-10-01 | Use %z* for size_t | Stefan Fritsch |
| 2012-12-31 | Spell `calculation' correctly. | Miod Vallat |
| 2012-12-05 | Remove excessive sys/cdefs.h inclusion | Theo de Raadt |
| 2010-08-27 | remove the unused if_init callback in struct ifnet | Jonathan Gray |
| 2010-08-07 | No "\n" needed at the end of panic() strings. | Kenneth R Westerback |
| 2010-08-06 | ACPI suspend/resume for bwi(4). Initial diff from todd@, finished and | Marcus Glocker |
| 2010-05-19 | BUS_DMA_ZERO instead of alloc, map, bzero. | Owain Ainsworth |
| 2009-09-13 | M_DUP_PKTHDR() define -> m_dup_pkthdr() function to properly deal | Kenneth R Westerback |
| 2009-08-02 | timeout_add -> timeout_add_msec | Bret Lambert |
| 2009-07-25 | Fix crash in bwi on armish by properly aligning a 32-bit value. Not | Kenneth R Westerback |
| 2009-07-19 | Include 0x4402 in the bbp id mapping table used on older | Jonathan Gray |
| 2009-06-02 | change a sizeof() to nitems() because the array subtype is a short. | Theo de Raadt |
| 2009-05-24 | declare a variable at the start of bwi_dma_free() instead | Jonathan Gray |
| 2009-01-21 | Replace timeout_add(msecs * hz / 1000) with timeout_add_msec(msecs). | Alexander Yurchenko |
| 2009-01-07 | declare bwi_modtype enum before it is used in function prototypes. | Jonathan Gray |
| 2008-11-26 | dont have bpf.h expose the kernel ticks variable wherever it is includeing. | David Gwynne |
| 2008-10-15 | Second pass of simple timeout_add -> timeout_add_sec conversions | Bret Lambert |
| 2008-08-27 | another IEEE80211_RADIOTAP_F_FCS candidate. | Damien Bergamini |
| 2008-08-27 | override net80211's ic_node_alloc function to allocate a full | Damien Bergamini |
| 2008-08-27 | introduce new IEEE80211_STA_ONLY kernel option that can be set to | Damien Bergamini |
| 2008-08-22 | a ; in a bad place; dragonfly; ok mglocker | Theo de Raadt |
| 2008-07-21 | instead of passing rx tstamp and rssi to the ieee80211_input function, | Damien Bergamini |
| 2008-06-11 | Don't get the address of the txstats pointers when doing bzero, | Jonathan Gray |
| 2008-04-16 | Kernel implementation of the 4-way handshake and group-key | Damien Bergamini |
| 2008-02-25 | Make bwi compile in debug mode again. | Marcus Glocker |
| 2008-02-25 | Sync up with DragonFlyBSD driver. Please read their commit message | Marcus Glocker |
| 2008-02-16 | Zap KKASSERT porting macro and use KASSERT instead. | Marcus Glocker |
| 2008-02-16 | Count output packets. | Marcus Glocker |
| 2008-02-16 | Replace bwi_rate2plcp() with ieee80211_rate2plcp(). | Marcus Glocker |
| 2008-02-16 | Fix spacing / comments. | Marcus Glocker |
| 2008-02-16 | While importing the driver a lot of printf's have been converted to | Marcus Glocker |
| 2008-02-16 | Report rssi and rate in rx radio tap. | Marcus Glocker |
| 2008-02-16 | Better support for 11b mode. | Marcus Glocker |
| 2008-02-16 | Remove some double prototype definitions. | Marcus Glocker |
| 2008-02-16 | Always print device name in front of debug messages. | Marcus Glocker |
| 2007-11-17 | - Add more LED support, like activity blinking (though just supporting | Marcus Glocker |
| 2007-10-18 | Add some first LEDs support. Tested on my cardbus Linksys WPC54G Ver 3. | Marcus Glocker |
| 2007-10-04 | Since we know the firmware load works, merge the single firmware files | Marcus Glocker |
