| Age | Commit message (Expand) | Author |
|---|
| 2005-11-07 | splimp -> splnet | Brad Smith |
| 2005-07-02 | clear IFF_RUNNING & IFF_OACTIVE in foo_stop() before de-allocating resources. | Brad Smith |
| 2005-04-25 | csum -> csum_flags | Brad Smith |
| 2005-04-23 | style | Brad Smith |
| 2005-01-15 | make sure interface is in RUNNING state before touching the multicast filters | Brad Smith |
| 2004-11-01 | back out previous commit. | Brad Smith |
| 2004-10-31 | don't swap zeros | Brad Smith |
| 2004-10-23 | add missing braces, noticed by mcbride@ | Brad Smith |
| 2004-10-23 | re-add old xl_encap_90xB() for 905B/C cards. removed in rev 1.52. | Brad Smith |
| 2004-10-02 | remove if NVLAN here too | Brad Smith |
| 2004-09-28 | remove if NVLAN around IFCAP_VLAN_MTU | Brad Smith |
| 2004-09-23 | don't need to set ifp->if_mtu or ifp->if_output in each driver, | Brad Smith |
| 2004-06-04 | fix conversion to ether_crc32_be(). problem noticed by naddy@ | Brad Smith |
| 2004-06-01 | dv_xname is not the same as dv_unit (for hell knows what reason) | Michael Shalayeff |
| 2004-05-30 | a bit of syncing with the FreeBSD driver, namely... | Brad Smith |
| 2003-10-21 | typos from Tom Cosgrove; | Jason McIntyre |
| 2003-06-29 | remove usage of xl_unit | Jason Wright |
| 2003-03-24 | splimp() around xl_reset() during autoconf. something in xl_reset() wants | Jason Wright |
| 2003-01-05 | spelling | Theo de Raadt |
| 2002-12-02 | - Remove a few magic constants | Jason Wright |
| 2002-11-25 | remove printf's in xl_setmode(). | Brad Smith |
| 2002-11-17 | Make sure never to put a loaded dmamap in the spare. 3c90x should work | Jason Wright |
| 2002-11-17 | this driver has never been in sys/pci (in OpenBSD at least) and supports | Jason Wright |
| 2002-11-17 | Fix another case (tx this time) where buffers were not unloaded (nor sync'd).... | Jason Wright |
| 2002-11-17 | - lightly season with htole32 and friends... enough to get rx working | Jason Wright |
| 2002-08-22 | simplify multicast setup on the 3c905 (pre-B/C, etc) | Jason Wright |
| 2002-07-09 | Don't write 32 bits to a 16-bit register. | Aaron Campbell |
| 2002-06-15 | Check the correct variable when freeing the RX/TX lists. | Aaron Campbell |
| 2002-06-15 | bus_dma'ify. Tested on 3c900(pci), 3c905b(pci), and 3c575c(cardbus). Thanks | Aaron Campbell |
| 2002-06-09 | a step towards consistancy; in general: | Todd T. Fries |
| 2002-06-08 | Add hardware TCP/IP checksum offloading support for receive and transmit for | Aaron Campbell |
| 2002-03-14 | First round of __P removal in sys | Todd C. Miller |
| 2002-02-15 | Don't cast nonexistent return value from splx to (void). ok art@ | Thomas Nordin |
| 2002-01-25 | Disestablish *powerhook* on detach. jason@ ok | Thomas Nordin |
| 2001-12-15 | Disestablish the powerhook on detach. ok jason@ | Thomas Nordin |
| 2001-11-06 | Replace inclusion of <vm/foo.h> with the correct <uvm/bar.h> when necessary. | Miod Vallat |
| 2001-08-19 | Don't reset rx/tx without turning them back on after suspend (Beck is now | Jason Wright |
| 2001-08-19 | Add a powerhook for bringing the 556 out of sleepy mode after suspend. | Jason Wright |
| 2001-08-12 | remove some of the redundant vm includes | Michael Shalayeff |
| 2001-08-03 | This driver allows vlan sized frames on 905B, set IFCAP_VLAN_MTU on that chip | Chris Cappuccio |
| 2001-07-02 | these don't depend on pci register defs | Jason Wright |
| 2001-06-27 | ALTQ'ify network drivers. | Kenjiro Cho |
| 2001-06-23 | ether_input_mbuf(). | Federico G. Schwindt |
| 2001-04-08 | Don't print anything for transmission error 90, since the driver always | Aaron Campbell |
| 2001-03-25 | Missing splx(). Thanks to Dawson and team for finding this | Constantine Sapuntzakis |
| 2001-02-20 | for ethernet ifaces attach bpf from ether_ifattach; jason@, aaron@, itojun@ ok | Michael Shalayeff |
| 2001-02-02 | No need for xl(4) to report tx underruns, they are much too common, and the | Aaron Campbell |
| 2001-01-12 | add SIOCSIFMTU; angelos@ coached | Todd T. Fries |
| 2000-11-09 | new timeouts | Michael Shalayeff |
| 2000-10-19 | if vlans are in use, then set the 3c905b to accept frames of size 1518. | Jason Wright |
