| Age | Commit message (Expand) | Author |
|---|
| 2009-11-25 | Just some minor cleanup. OK deraadt@ | Claudio Jeker |
| 2009-11-25 | Consider any tx buffer that is freed in vr_stop() to be an unsent | Theo de Raadt |
| 2009-11-25 | Re-enable the debug messages from bus errors and tx underruns so that | Theo de Raadt |
| 2009-11-25 | Do not call vr_stop() and vr_reset() before calling vr_init(), because | Theo de Raadt |
| 2009-08-13 | - consistify cfdriver for the ethernet drivers (0 -> NULL) | Jasper Lievisse Adriaanse |
| 2009-08-10 | A few more simple cases of shutdown hooks which only call xxstop, when | Theo de Raadt |
| 2009-08-09 | MCLGETI() will now allocate a mbuf header if it is not provided, thus | Theo de Raadt |
| 2009-06-18 | Remove the if (1) that makes blambert@ cry. Appreciated blambert@ | Claudio Jeker |
| 2009-06-18 | MCLGETI support for vr(4) interfaces. This will make the newer soekris and | Claudio Jeker |
| 2009-06-04 | move redundant bus_dmamap_sync calls outside an if/else block. | Stuart Henderson |
| 2009-05-29 | Return the RX descriptor after pointing it to the new mbuf. | Marco Pfatschbacher |
| 2009-05-21 | always set VR_RXCFG_RX_MULTI when setting the chip into promiscuous | Stuart Henderson |
| 2009-05-12 | cleanup and simplify promiscuous/multicast setup (setmulti -> iff). | Stuart Henderson |
| 2009-05-12 | Fix the URL for datasheets. | Stuart Henderson |
| 2009-05-11 | in the case where mbufs had to be copied _and_ checksums were enabled, | Stuart Henderson |
| 2009-05-11 | preliminary parts for hw vlan tag insertion/removal, ideas gleaned from | Stuart Henderson |
| 2009-05-11 | On VT6105M, use hardware IP, TCP and UDP checksums in and out. Tested on | Stuart Henderson |
| 2009-05-11 | Start using VR_RXSTAT_RX_OK instead of VR_RXSTAT_ERR (It exists | Stuart Henderson |
| 2009-05-10 | - fix whitespace problems (introduces no change with diff -w) | Stuart Henderson |
| 2009-05-10 | - use nitems() rather than handrolled version. | Stuart Henderson |
| 2009-05-10 | - change device matching to use a quirks table. | Stuart Henderson |
| 2009-04-30 | The previous change did not always update vr_link on rlphy(4) based | Marco Pfatschbacher |
| 2009-04-28 | The TX engine can get stuck if the interface went through a link | Marco Pfatschbacher |
| 2009-03-29 | make various strings ("can't map mem space" and similar) more consistent | Stuart Henderson |
| 2008-11-28 | Eliminate the redundant bits of code for MTU and multicast handling | Brad Smith |
| 2008-10-14 | Change m_devget()'s outdated and unused "offset" argument: It is | Christian Weisgerber |
| 2008-10-02 | First step towards cleaning up the Ethernet driver ioctl handling. | Brad Smith |
| 2008-09-24 | Fix a vr(4) panic that occurs under high load. | Marco Pfatschbacher |
| 2008-09-10 | Convert timeout_add() calls using multiples of hz to timeout_add_sec() | Bret Lambert |
| 2008-07-24 | dont need malloc.h anymore; plus two tiny whitespace fixes | Thordur I. Bjornsson |
| 2008-07-18 | o Use mbufs, for the RX ring, instead of malloc()'ing an MCLBYTES sized buffer. | Thordur I. Bjornsson |
| 2008-05-22 | More timeout(9) usage cleaned up. | Michael Knudsen |
| 2008-02-07 | Add the SIOCSIFMTU ioctl to allow ioctl changes; | Thordur I. Bjornsson |
| 2007-11-26 | typos; ok jmc@ | Martynas Venckus |
| 2007-10-02 | In vr_attach() only touch the VR_STICKHW register if the adapter | Brad Smith |
| 2007-09-12 | Remove the old software bit-banging MII interface, we started using | Brad Smith |
| 2007-09-01 | Add VLAN reception support to vr(4). Diff from Brad. | Marcus Glocker |
| 2006-11-03 | vr_rxeof(): stick receive error messages under VR_DEBUG. | Brad Smith |
| 2006-11-03 | vr_intr(): remove duplicate check for VR_ISR_RX_NOBUF and the "packet lost" | Brad Smith |
| 2006-09-22 | put a few printf's in the interrupt handler under VR_DEBUG. | Brad Smith |
| 2006-06-17 | add sys/timeout.h | Brad Smith |
| 2006-05-28 | unknown ioctl is ENOTTY not EINVAL | Jason Wright |
| 2006-04-28 | check for IFF_RUNNING being set before calling vr_init(). | Brad Smith |
| 2006-03-25 | allow bpf(4) to ignore packets based on their direction (inbound or | Damien Miller |
| 2006-03-20 | de-register. | Brad Smith |
| 2006-02-07 | move the devices list up a bit. | Brad Smith |
| 2006-02-06 | vr_start(): return if IFF_OACTIVE is set. | Brad Smith |
| 2006-02-05 | make sure to set or clear the RX mode promiscuous bit. | Brad Smith |
| 2006-02-05 | call vr_setmulti() if adjusting PROMISC or ALLMULTI and do not do a full | Brad Smith |
| 2006-01-14 | - the allmulti target initially enables all multicast mode so don't bother | Brad Smith |
