summaryrefslogtreecommitdiff
path: root/sys/dev
AgeCommit message (Expand)Author
2010-02-18fix a few capitalizations of QLogic.Igor Sobrado
2010-02-18improve startup messages displayed by isp(4) in such a way entriesIgor Sobrado
2010-02-17Make sure we claim the interrupt as ours if the time out bit is set in theMark Kettenis
2010-02-17read calibration version from ROM and set IWN_GP_DRIVER_CALIB_VER6Damien Bergamini
2010-02-17KNFPaul Irofti
2010-02-17change constant of convert formulra of SHT1X sensor to fitYojiro Uo
2010-02-16fix AR_DTIM_PERIODDamien Bergamini
2010-02-16Recognize the BCM57780 PHY, tested by bruce on tech@.Stuart Henderson
2010-02-16syncStuart Henderson
2010-02-16Add BCM57780, from Brad. ok jsg@ kettenis@Stuart Henderson
2010-02-16Use i2c_addr_t as the type for the init_xfer function because thisMichael Knudsen
2010-02-15regenDamien Bergamini
2010-02-15add MSI (Micro Star International) vendor and RT3090 product idDamien Bergamini
2010-02-15Properly detect when the band changes from 2GHz to 5GHz andDamien Bergamini
2010-02-15- handle SIOCS80211CHANNEL in monitor mode without doing a full resetDamien Bergamini
2010-02-14The ASIC does not like PCI bursts on registers because of a silicon bug.Damien Bergamini
2010-02-13Force chunks into correct order once metadata is attached. This preventsJoel Sing
2010-02-13Unbreak automatic rebuilds from hotspares.Joel Sing
2010-02-13Removed unused variable sml_vn.Joel Sing
2010-02-13Pass the number of chunks to sr_meta_attach() rather than recalculating.Joel Sing
2010-02-11"unmute" GPIO 0 on all Dell machines with IDT 92HD71B7 codecs.Jacob Meuser
2010-02-11No need for M_CANFAIL if M_NOWAIT is used. Found by Gleydson Soares.Claudio Jeker
2010-02-10Only allow the common voltages of the card and the host when writing the OCRDale Rahn
2010-02-10check that rf reg is != 0xff, not rf val.Damien Bergamini
2010-02-09Build ral firmware on loongson (for Gdium).Miod Vallat
2010-02-09XY Failure reads no longer require temp buffer or WUF_FAILJordan Hargrave
2010-02-08Use character raw device to read disklabel during bootprobe, as allKenneth R Westerback
2010-02-08Add ZTE K3565-Z USB MSM modem.Marco Pfatschbacher
2010-02-08syncMarco Pfatschbacher
2010-02-08Add ZTE K3565-Z USB MSM modem.Marco Pfatschbacher
2010-02-08remove redundant bits.Damien Bergamini
2010-02-08final bits for RT3572 and some fixes for RT3070 and RT3071.Damien Bergamini
2010-02-08add the 10us sifs directly to the pre-computed ack durations.Damien Bergamini
2010-02-08simplifyDamien Bergamini
2010-02-08s/RT2860_MCU_CMD_BOOT/RT2860_MCU_CMD_RFRESET/Damien Bergamini
2010-02-08fix BBP R82 for RT3572Damien Bergamini
2010-02-08When initialising the chip actually set the hardware MAC address, thusJoel Sing
2010-02-07regenMark Kettenis
2010-02-07Add VIA VT8251 AHCI.Mark Kettenis
2010-02-07writing to RT2860_TX_PIN_CFG requires some extra steps on RT3572Damien Bergamini
2010-02-07fix my 1.44->1.45 commitDamien Bergamini
2010-02-07HT is not enable so skip this.Damien Bergamini
2010-02-07we're in 2010.Damien Bergamini
2010-02-07add two more ids for RT3572 and one more id for RT2770.Damien Bergamini
2010-02-07set default value for BBP R106Damien Bergamini
2010-02-07set tx mixer gain for RT3071Damien Bergamini
2010-02-07change RF init sequence for RT3572Damien Bergamini
2010-02-07cleanup run_rt3070_set_chanDamien Bergamini
2010-02-07add a function to set the channel on RT3572.Damien Bergamini
2010-02-07when calibrating filter, use better target values for >=RT3071Damien Bergamini
generated by cgit v1.2.3 (git 2.25.1) at 2024-11-24 20:19:02 +0000