| Age | Commit message (Expand) | Author |
|---|
| 2006-09-18 | g/c unused SK_{SET,CLR}BIT macros | Brad Smith |
| 2006-09-18 | There's no need to walk the list of devices to find the SCSI bus we | Pedro Martelletto |
| 2006-09-18 | regen | Brad Smith |
| 2006-09-18 | add entries for unknown Marvell SATA and ServerWorks IDE PCI ids. | Brad Smith |
| 2006-09-18 | regen | Brad Smith |
| 2006-09-18 | - fix typo in Corollary vendor name | Brad Smith |
| 2006-09-18 | More uath devices, also properly mark some of the UB52/AR5005UX devices | Jonathan Gray |
| 2006-09-18 | regen | Jonathan Gray |
| 2006-09-18 | More uath devices. | Jonathan Gray |
| 2006-09-17 | add a flag to indicate which boards are only capable of 10/100 modes of | Brad Smith |
| 2006-09-17 | Readd the Dell PHY LED setup workaround and the Jumbo capability flag. | Brad Smith |
| 2006-09-17 | Try to reclaim the TX descriptors in the watchdog handler before actually | Brad Smith |
| 2006-09-17 | Overhaul RX path to recover from mbuf cluster allocation failure. | Brad Smith |
| 2006-09-17 | do not fill in the anar for the manual 1000baseT media setting case. | Brad Smith |
| 2006-09-17 | Move get ipmi id into the match function. This prevents attach from being | Marco Peereboom |
| 2006-09-17 | Re-add the link state check to re_start(), which was added in rev 1.31 and | Brad Smith |
| 2006-09-17 | set the IFCAP_VLAN_MTU flag. | Brad Smith |
| 2006-09-17 | revert revision 1.131, the code in question was later found to not ensure | Brad Smith |
| 2006-09-17 | - correct the firmware synchronization in bge_reset(), this | Brad Smith |
| 2006-09-17 | defer establishing the interrupt until later during attach, to let the | Brad Smith |
| 2006-09-16 | add new uath(4) ids and fix existing ones. | Damien Bergamini |
| 2006-09-16 | sync (uath) | Damien Bergamini |
| 2006-09-16 | add new uath(4) ids and fix existing ones. | Damien Bergamini |
| 2006-09-16 | sync (uath) | Damien Bergamini |
| 2006-09-16 | more uath(4) usb ids. | Damien Bergamini |
| 2006-09-16 | indent | Damien Bergamini |
| 2006-09-16 | fix a buggy printf. | Damien Bergamini |
| 2006-09-16 | sync (uath) | Damien Bergamini |
| 2006-09-16 | Initial import of uath(4), a driver for Atheros USB2.0 AR5005UG/AR5005UX | Damien Bergamini |
| 2006-09-16 | Get subvendor from the PROM instead of the PCI configuration space, since the | Mark Kettenis |
| 2006-09-16 | Don't panic if firmware files are not in place. Ja ja ja ja claudio@. | Marcus Glocker |
| 2006-09-16 | Bring pgt(4) in a working state. Much work also done by claudio@. | Marcus Glocker |
| 2006-09-16 | rework the handling of the errors coming off the hardware at the bottom of | David Gwynne |
| 2006-09-16 | Asking for HWERR interrupts and not acknowledging them leads | Jonathan Gray |
| 2006-09-16 | Support for Intel 6321ESB SATA. Tested on one of cloder's new | Jonathan Gray |
| 2006-09-16 | Match VIA VT8237A SATA which while untested should act like | Jonathan Gray |
| 2006-09-16 | regen | Jonathan Gray |
| 2006-09-16 | VIA VT8237A SATA | Jonathan Gray |
| 2006-09-15 | Reserve some commands slot for bioctl/sensorsd so ciss doesn't crash | Kenneth R Westerback |
| 2006-09-15 | Kettenis's polished version of diff to preserve the mac address on thecus, | Dale Rahn |
| 2006-08-31 | ciss can't do bio ioctl's when >1 logical device is defined. Bail out | Kenneth R Westerback |
| 2006-08-31 | Start to get interface attach working. | Marcus Glocker |
| 2006-08-31 | Some first cleanup run. | Marcus Glocker |
| 2006-08-31 | Bring chip into initialized state. | Marcus Glocker |
| 2006-08-31 | Oops! Disable debug. | Marco Peereboom |
| 2006-08-31 | Add sensor thread for individual sd devices. | Marco Peereboom |
| 2006-08-31 | Do proper chipset identification. | Marcus Glocker |
| 2006-08-31 | Prerrt print volume nr in dmesg. | Marco Peereboom |
| 2006-08-31 | Get firmware loaded. | Marcus Glocker |
| 2006-08-30 | Try to read station address from the chip first, then try the EEPROM (if we | Mark Kettenis |
